Evaluate which branches should stay or be removed.
Jul 24, Prune rubber tree plant by making your cuts just above a node– where the leaf attaches to the stem or where another stem branches off. You can also prune just above a leaf scar. Remove about a third to one-half of the plant’s branches but take care not to Estimated Reading Time: 2 mins. A minimum of two leaves should be left behind on a small Rubber Plant’s stem, or six to ten leaves on each branch of a larger plant.
Pruning should be done with a sharp, sterile blade. Trim just above a node, or growing point. You can cut straight across or at a 45º angle. New branches emerge below the cut. May 24, 3. Wear gloves when pruning. The sap of the rubber plant is sticky, and will start to flow from the cuts you make when pruning the branches.
To prevent the sticky sap from getting onto your fingers, wear a pair of gloves while pruning.
Rubber tree cuttings require humid environments to sprout roots.
Canvas work gloves would suffice, as would rubber 94%(19). Jul 22, Remove branches with tight angle crotches, which tend to be weak. Prune to remove up to a third of the rubber tree plant's leaves and stems. Cut back lateral branches. Jun 08, A rubber tree plant is also known as a Ficus bushcleanup.bar large trees can grow up to 50 feet (15 m.) tall. When learning how to care for a rubber tree plant, there are a few key things to remember, but rubber plant care isn’t as difficult as one might think.
Jan 20, Water your rubber tree when the soil is slightly dry to the touch. Watering too often may cause leaf yellowing. Dump out the saucer beneath the pot so there's no standing water. If you like, feed your rubber tree with a general-purpose fertilizer at 1/4 to 1/2 strength a few times a year, especially during active growth in spring and bushcleanup.barted Reading Time: 4 mins. Rubber Trees have a tendency to bleed a lot of sap when they are cut, so I would recommend that you have some Roottone or Hormonex handy to cover the fresh wounds.
(these products will aid in the callousing process). Sep 29, Planting & Potting Your Rubber Plant. Rubber trees are finicky when it comes to change, so be sure to pick a spot to place it and don’t move it. This is especially true when it comes to fluctuations in temperature or air flow. Rubber Tree Plant Care Sun. Rubber trees do not require much light, but flourish in bright, indirect light.
May 24, Place in a Warm, Sunny Location, and Wait. Place the cuttings, including the bags, in a warm location that receives dappled sun throughout the day. Avoid direct sun as it will burn the leaves and cause the cuttings to shrivel up and dry out. After four to five weeks, the cutting should begin establishing roots.
Oct 27, Aside from removing dead or dying leaves, rubber plants don’t require much pruning. However, for shaping, keep the following in mind: Don’t cut off the top until your plant reaches the desired height. When you do cut off the top, your plant will branch out. You can always prune to your desired shape by cutting back unruly bushcleanup.barted Reading Time: 5 mins.